.png){kind=small}
.png){kind=small}
Showing all 90 results
Filters
Sort results
Reset
Apply
 |
This mold is designed primarily for embedding cell culture specimens grown either directly on the… Show more (+) This mold is designed primarily for embedding cell culture specimens grown either directly on the bottom of a dish or on the filter when cross sections of the cells are needed Show less (-) |
 |
The Embedding Capsule SubstituteIt is easier to see inside the well when centering the… Show more (+) The Embedding Capsule SubstituteIt is easier to see inside the well when centering the specimen in the tipIt is easier to remove the block from the well. There is no need for razor blades or press devicesThe finished blocks have finer tips so when you trim deeper into the block the face doesn't increase in size rapidly; therefore, constant retrimming is not necessary Show less (-) |
 |
The Mold for Long TissuesThis mold accommodates longer pieces of tissues (muscle, skin biopsies, and… Show more (+) The Mold for Long TissuesThis mold accommodates longer pieces of tissues (muscle, skin biopsies, and many plant specimens)AdvantagesEasy to embed long specimens and orient them properly. The tissues lie flat in the well; therefore, no horizontal trimming is neededIt is ideal for any specimen that needs immediate sectioning (e.g. cell monolayer). 24 cavities Show less (-) |
 |
The mold yields several individual blocks of resin from a single slip-coverThe resin blocks fit… Show more (+) The mold yields several individual blocks of resin from a single slip-coverThe resin blocks fit directly into a chuck for flat specimensThe embedded surfaces are free from blemishes caused by entrapped airThe mold uses a minimum amount of resin Show less (-) |
 |
Machined from aluminum rods with one end tapered to 4.8mm in diameter. The specimen… Show more (+) Machined from aluminum rods with one end tapered to 4.8mm in diameter. The specimen can be oriented and mounted to the tip with glue and it is ready for sectioning. The body size is "00" and it measures 11mm long. Show less (-) |
 |
Knife angle : 20°
Boat type : Triangular holder
Application : Trimming biological and materials… Show more (+) Knife angle : 20°
Boat type : Triangular holder
Application : Trimming biological and materials science specimens Show less (-) |
|
Knife angle : 45°
Boat type : Triangular holder
Application : Trimming biological and materials… Show more (+) Knife angle : 45°
Boat type : Triangular holder
Application : Trimming biological and materials science specimens Show less (-) |
 |
A new design with 10 triple numbered, tapered tip cavities to save you time and… Show more (+) A new design with 10 triple numbered, tapered tip cavities to save you time and handling. Holds firmly in a chuck during trimming or sectioning. Made from white silicone, each cavity measures 8mm from tip to center, 5mm Deep. Show less (-) |
 |
Knife angle : 35°
Tickness range [nm] : 30 - 200
Boat type : Standard… Show more (+) Knife angle : 35°
Tickness range [nm] : 30 - 200
Boat type : Standard boat
Application : Biological and materials science specimens
Show less (-) |
 |
Knife angle : 45°
Tickness range [nm] : 30 - 200
Boat type : Standard… Show more (+) Knife angle : 45°
Tickness range [nm] : 30 - 200
Boat type : Standard boat
Application : Routine sectioning of Biological and materials science specimens
Show less (-) |
