.png){kind=small}
.png){kind=small}
Showing all 14 results
Filters
Sort results
Reset
Apply
 |
These 2 part molds may be used for all cold embedding epoxies. Comes with a… Show more (+) These 2 part molds may be used for all cold embedding epoxies. Comes with a detached cap for easy removal. The molds come in 3 different sizes to accommodate all of the samples you may have. The molds are made from HDPE and we recommend the use of mold release spray (Catalog #72619) prior to use. Show less (-) |
 |
Cold mounting or embedding is when a resin is mixed with a hardener (or accelerator)… Show more (+) Cold mounting or embedding is when a resin is mixed with a hardener (or accelerator) to provide the mounting compound, and then the polymerization process take place to form the block. In some cases, this process gives-off heat. However this heat generation can be controlled by the use of ice or cool air blow setting. […] Show less (-) |
 |
Mounting Cups for Cold Mounting/Embedding
Polyethylene, one part molds. Closed one end. Red |
 |
Formulated specifically for the preparation of petrographic thin sections, EMS Petrographic Epoxy Kits are the… Show more (+) Formulated specifically for the preparation of petrographic thin sections, EMS Petrographic Epoxy Kits are the only epoxy mounting medium which is supplied with everything needed to dispense, mix and apply the medium. No more guessing at proportions, and improvising stirring rods and mixing containers. Technical Data Sheet : EMS Petrographic Epoxy Best Refractive Index – […] Show less (-) |
 |
The rectangular flexible moldis made of very flexible transparent silicone rubber which makes it very… Show more (+) The rectangular flexible moldis made of very flexible transparent silicone rubber which makes it very easy to remove the mounts. The inner sides are polished, so the sides of the mounts get clear. The sides are also straight which makes it easier to fasten the mounts in a specimen holder
Technical Data Sheet : flexible_Mold Show less (-) |
 |
The form mold is a two part mounting cup, designed to be as user-friendly as… Show more (+) The form mold is a two part mounting cup, designed to be as user-friendly as possible. It has practical handles for removing of the lid and the cylinder is slightly conical for easy removal of the mounts.
Technical Data Sheet Show less (-) |
 |
MSDS_50494-25
MSDS_72619 |
|
When preparation requirements include less expensive, uniform size and shape, and short processing times, hot… Show more (+) When preparation requirements include less expensive, uniform size and shape, and short processing times, hot mounting (hot compression mounting) is ideal. Hot mounting takes place under pressure in a mounting press, where the specimen is placed in a cylinder together with the appropriate mounting resin. A temperature of up to 200°C, and a pressure of […] Show less (-) |
 |
Mounting cup with parallel sides that help avoid tilting of the mount when clamped into… Show more (+) Mounting cup with parallel sides that help avoid tilting of the mount when clamped into a specimen holder. Show less (-) |
 |
Impregnated phenolic, ¾" high |
